As far as design is concerned, automatic screw feeder drivers are quite easy to use. The operator can replace a shaker tree or open bin as the screw supply. All they need to do is touch the tooltip, turn and then fasten it to the right area. So, you don’t need to look for the screw. This boosts the throughput. Apart from this, fully automated systems make use of screw feeders in simple ways. Let’s find out how beginners can use these systems.
A robotic arm spins and fastens the screw rather than an operator. The role of the system is to make the screw supply process simpler for robotic assembly or operators. So, the use of the machine depends on the system engineer or designer.
Also, the operator already knows the right way to use the machine. However, it boils down to the engineer or designer to decide on the method, location, and time of the deployment of each unit. And this can be quite difficult for them.
After all, the idea is to get the most out of the investment dollars. Given below are some of the tips for engineers and designers to use automatic screw feeder drivers to get success.
Know Your Product
As far as the installation of the screw presenter machine is concerned, the assembly speed can be greatly boosted. If a product requires more than 40 screws of the same size, only one machine will be more than enough to get the job done.
For maximum benefits, you can multiply the time saved by the number of screws. Also, if the time saved outweighs the cost of investment, the automatic screw feeder driver can be an ideal choice for your business.
Position the Screw Feeders the right way
You should make sure that the screw feeder is applied to the right product. Besides, you also need to ensure that it is positioned the right way in the assembly process. Given below are some of the factors that can help decide on the right location for the unit:
- Make sure it’s integrated into the assembly flow properly
- Make sure It’s easy to access
- Make sure it’s easy to fill again and maintain
If you manufacturer in a cell, line, or a combo process, make sure you put a good workstation and screw presenter in the right location. Typically, the workstation must be placed closest to the last assembly station of the product. Therefore, it should pass via the line quickly. The assembly flow efficiency may offset the gains obtained by the screw feeder. Therefore, make sure you directly locate the screw feeder.
An automatic screw presenter can boost your assembly speed. As a result, the process can move up to 50% faster. But if you want to get this level of efficiency, make sure you take care during the screw supply designing process.
In short, this is how you can use an automatic screw feeder driver, especially if you are just getting started in this field.