8 Tips to Use an Automatic Screw Feeder Machine the Right Way

An automatic screw feeder machine has to be used with great care. Professionals like repairers and manufacturers can greatly benefit from these machines. Basically, the choice of these units is based on whether the professionals are experienced enough to use the units. In this article, we have given some tips to help you understand how to use these screw feeders the right way.

1. Inspect your Assembly line first

It can be difficult to install these machines. Therefore, you should consider the assembly unit in your workplace first. Since it’s going to be a long-term investment, make sure you take this decision after careful consideration.

So, it makes sense to inspect your assembly unit thoroughly prior to investing your investment dollars in these machines. Also, if you don’t need to tighten more than few screws per day, it may not be a good idea to buy an automatic screw feeder unit.

But if you need to fix hundreds of screws on a daily basis, then you must look into buying one. In this case, buying an automatic screw feeder is a stroke of genius as these units will help you reduce your effort significantly.

2. Consider the Location of Installation

For the most benefit, make sure you consider the location where the machine will be installed. What you need to do is check the location before installing the machine. The location should be suitable. In other words, it shouldn’t be far away from the operator or the spot where you can’t access it easily.

3. Choose a Solid Base

The place where you are going to fix the product must be solid enough. Since this is an electronic device, it will serve as a robot as well. Therefore, the place underneath the machine has to be rigid. Therefore, make sure that the place is not soft, rough or moveable.

4. Power Connection

Before you make the power connection, make sure that the unit is properly fixed using the right fittings. If you leave the unit as is, it may be dangerous when the power supply is attached. Therefore, it makes sense to check the unit prior to connecting power.

5. Follow Specifications

Make sure you choose specified screws only based on the design of the machine. If you don’t use the right type of screws, you may end up causing severe damage to the machine.

6. Keep a Safe Distance

While using the machine, make sure you maintain the proper distance between you and the machine. You should keep your fingers and hands at a safe distance from the unit.

7. Shut Down Right Away

If the unit doesn’t seem to work properly for some reason, shut it down immediately and disconnect the power supply as well.

8. Modifications

Don’t make the mistake of repairing or damaging any outdated or damaged part. It’s better that you leave these tasks to a professional.

Final Verdict

So, if you want to use your automatic screw feeder machine the right way, we suggest that you follow the tips given in this article. This will help your machine stand the test of time and save you loads of money over the long haul.